-
Mold temperature control system for high gloss and non trace injection molding process
2018-05-24The key of high gloss injection is mold temperature control system. Because the highest difference between high gloss injection and general injection is the control of mold temperature, and the requirement for injection molding machine is not high. The high light injection mold temperature ......[More]
-
Effect of dehumidification dryer
2018-05-24A good drying efficiency determinant is 4 points as follows: drying temperature DryTemperatur, drying time Residtime, air volume Airflow, temperature Dewpoint, and these four factors ring around each other, the change of any one condition will affect the drying effect....[More]
-
The correct method of selecting and buying the mould temperature machine
2018-05-24One, select the appropriate model temperature controller: random selection model temperature control products DC high voltage generator can bring 20% profit loss at any time, so we must consider the needs of production in detail, and strictly determine the ability of the model temperature controller, in order to make a decision. Unfortunately, people often overlook the extremely important part of the injection molding technology. They often wake up when productivity and quality problems arise....[More]
-
Congratulations on the successful conclusion of the first machinery in the Fourteenth International
2018-05-24The Fourteenth International Machinery and equipment exhibition in Houjie, Dongguan in from November 14 to 18, 2012, successfully participated in the exhibition and achieved many opportunities....[More]
-
Introduction of silicification processing technology
2018-05-24The silicification process is to hydrolyze the glass (mainly SiO2) into a colorless transparent colloidal substance.
Then a special catalyst was added to the colloid.
The gelatinous material and catalyst mixture coating on plastic materials (usually PC, PMMA, PA etc.) surface;
At last, under certain conditions, a dense layer of silicified film (also known as glass film) is formed on the surface of the plastic material, so as to improve the properties of the plastic part....[More]
